Used PRO EDGE IV with about 400 hours!
Spindle:
2/2.5 HP, 1710/3420 RPM
Pneumatic head travel with position lock (with pressure gauge
and adjustment); stroke length: 2"
Center water feed
Internal air purge system
Tool adapter to accept 100mm snail lock or 5/8-11 NC
connections
Shape tool adapter
Spindle Miter:
0 to 189 degree miter range
Hydraulic rack and pinion drive
Hardened alloy-steel C-arm with powder-coated finish
Rise and Fall:
3" rise and fall travel
Round rail precision guide system
Manual positioning with pointer/ruler display
Cross Travel:
Hydraulic, 15-100 FPM variable speed
Heavy-duty rack and pinion drive system
Cross travel carried on two chrome hardened steel rails with
slide bearings, automatically lubricated
Table and Clamping:
12'L x 4'W precision-machined tabletop work area with rubber
matted surface
Pneumatic, pop-up, "all way" rollers to assist in
positioning, loading and unloading stone (2,500 lbs. total
lifting capacity)
Five adjustable, pneumatic hold downs withaluminum extension
bars
Built-in storage for aluminum extension bars
Adjustable PARK bench to support long pieces
Construction:
Table: Heavy-duty structural steel/plate construction, stress
relieved and precision machined
Bridge: Tubular bridge design, stress relieved and precision
machined
Electrical and Plumbing Requirements:
Electrical power at machine: 240 volt (+/- 10%), 3 phase, 60
Hz, 30 amps required
Air at machine: 8 SCFM volume, 100 PSI pressure free of oil,
water and grit larger than 25 micron (3/8" I.D. air line)
Water supply at machine: 5 GPM, 50 PSI, filtered to 5 micron
(1/2" I.D. water line with clean, fresh water)
Capabilities:
A variety of convex edges (3/8" to 6" thick) and flat edges
3/8" to 4" thick) can be shaped and polished
A variety of concave edges can be shaped
Ogee edges can be shaped and polished
Shaping and polishing length: 1' to 12' long
Profile shaping and polishing thickness from 3/8" to 6"
(spindle adjustment required on stone over 2-1/2" thick,
must bevel corners on stone over 3" thick)
Radius capacity: 0" to 3" radius
"All way" rubber pop-up roller system allows work pieces to
be loaded and positioned easily without scratching or
breaking
The top line can be controlled on all types of stone to
achieve the profile blend that suits your needs
Bullnose edges, including laminates, are back gauged and
polished, even past the bottom transition line
Uniform edges on each individual job
An 80% reduction in labor cost on lineal footage can be
achieved
Unmatched setup time
Eliminates double-cutting of laminations
Compared to hand tools, abrasives cost per linear foot may be
reduced by as much as 60%
Specifications
Weight: 15,000 lbs.
Overall dimensions: 19'-2"L x 6"W x 8'-6"H
Floor space requirements: 23'L x 13'W x 8'6"H